Skip to content
SoluWeld

Weld volume calculator

Cross-section area, volume, deposited mass and filler metal to order, for the common ISO 9692-1 joint preparations.

Free access, no sign-up · Same formulas as the SoluWeld software calculation module.

The software itself offers many more materials and joint preparations, and more advanced charts.

Joint preparation
mm
mm
mm
°
t 10b 2c 2α 60°
Inputs
m
%

Flat allowance on the cross-section; 10% is the software default.

%

Typical published value for the process; editable.

Results

Groove area
57.0 mm²
Area with reinforcement
62.6 mm²
Weld volume
62.6 cm³
Deposited mass
0.49 kg
Filler metal to order
0.53 kg

0.492 kg/m · per metre

Estimate the cost of this weld

How the calculation works

Cross-section area by preparation (ISO 9692-1: α is the included groove angle, β the angle of one bevel measured from the vertical):

  • Square butt: A = t · b
  • Single V: A = (t − c)² · tan(α/2) + t · b
  • Single bevel: A = ½ · (t − c)² · tan(β) + t · b
  • Double V: A = h₁² · tan(α₁/2) + (t − c − h₁)² · tan(α₂/2) + t · b
  • Double bevel: A = ½ · h₁² · tan(β₁) + ½ · (t − c − h₁)² · tan(β₂) + t · b
  • Fillet: A = Z² / 2 (i.e. a², with Z = a · √2)

Volume V = A · (1 + reinforcement) · L; deposited mass m = V · ρ; filler metal to order = m ÷ deposition efficiency. Typical efficiencies come from published sources (NAVEDTRA 14251A, IWE course): 67% for covered electrodes including the stub, 93% for solid MIG/MAG wire, 100% for TIG excluding the stub.

This calculation, attached to your welds

In SoluWeld, each calculation is saved with its input data, attached to a project and a weld, and found again in the manufacturing record.